What is the correct calculated width for a pull box if all conductors enter the bottom and exit the right side with the value 4" X 6"?

To determine the correct calculated width for a pull box, it's important to consider the dimensions provided, which are 4 inches by 6 inches, along with the installation guidelines for pull boxes.

The width of the pull box is typically calculated based on the conductors' arrangement and the space needed to accommodate the bends and pull of the conductors. When conductors enter from the bottom and exit from the right, the pull box must allow enough space for the conductors to be pulled through without excessive strain or damage.

For a pull box with the specified dimensions of 4 inches by 6 inches, one must assess how much room is necessary for the bends and any additional clearance. The calculated width of 33.5 inches would take into account the standard practices described in the National Electrical Code (NEC) and ensure that there is sufficient room in the box for safe and efficient conductor handling.

While other choices may misinterpret the necessary dimensions based on improper assumptions about conductor spacing or pull requirements, the choice of 33.5 inches provides an adequate width that aligns with typically accepted practices for pull box installation. This choice reflects a careful consideration of the space required for the configuration of the conductors as described.